ARMCON MOLDS USA 127 Maple Lane, Lebanon, PA, USA 17042

Health and Safety requirements

Custom Title Excerpt
Health and Safety requirements
1
MATERIAL SAFETY DATA SHEET

Identification of Substance or Preparation
Name of Product : ARMCON CRA 3 – Product Code 43001

Information on Ingredients
Hazardous Ingredient : E.E.C. Number : Symbol/s Risk Phrases : Approximate Concentration %w/w

Hazards Identification
  • Inhalation : Inhalation of oil mist may cause irritation to the respiratory tract.
  • Skin : Repeated cantact may cause dermatitis.
  • Eyes: Liquid irritating to eye.
  • Ingestion: Exhibits slight acute oral toxicity
First Aid Measures
  • Inhalation: Remove to fresh air. If unconscious turn into the recovery position. Get medical help.
  • Skin: Wash with soap and water.
  • Eyes: Flush out with clean water for 10 minutes. Get medical help.
  • Ingestion: Do not induce vomiting. If patient vomits, turn to recovery position. Give water to drink. Get medical aid.
Fire Fighting Measures
  • Small Fires : Use carbon dioxide, dry chemical, foam, sand, earth, or water fog.
  • Large Fires : Use foam or water fog. Keep containers cool by spraying with water.
Storage and Handling Measures
  • Handling: Pump at no greater than 7 metres per second.
  • Storage: This product is a neutral mineral oil and can be stored in steel drums.
Exposure Controls (mg/m³)
and Personal Protection
  • O.E.S. Shr T.W.A.
  • O.E.L. 8hr T.W.A. 5 mg/m³ as oil mist.
  • O.E.L. Sol 8hr T.W.A.
  • M.E.L
  • Protection: Wear oil resistant gloves and suitable eye protection.
Physical and Chemical Properties
  • Formula: Not applicable
  • Vapour Density gm/L @ 20°C: Not applicable
  • Molecular Weight: Not applicable
  • Viscosity c.St. @ 20°C : (19.5 @ 40°C)
  • Solubility in Water : Insoluble
  • Vapour Pressure KPa @ 20°C : Not applicable
  • Appearance : Pale yellow liquid
  • Boiling Points °C : Not applicable
  • Solubility in Organics : Miscible with many
  • Freeze Point °C : Not applicable
  • Odour : Mild
  • Flash Point °C : 18°C
  • Evaporation Rate : Not applicable
  • Auto-ignition Temp. °C : 250
  • Density Kg/L @ 15°C : 0.878
  • Explosion Limits : Not applicable
Stability and Reactivity

Stable at normal temperatures and pressures. Not reactive at normal temperature and pressure conditions.

Toxicological Information
  • Inhalation : Not available
  • Skin contact : Not available
  • Eye contact : Not available
  • Ingestion : Not available
Ecological Information
  • None available
Disposal considerations

This material must be disposed of via an Authorized Waste/Disposal Company in accordance with Local and or National Waste Disposal Regulations

Transport Information
  • UN Number : None
  • Packing Group : None
  • C.A.S. Number : None
  • ICAO/IATA : None
  • Trem Card : None
  • E.M.S. : None
  • M.F.A.G. : None
  • I.M.D.G. : None
  • Marine Pollutant : No
  • E.E.C Number
  • A.D.R. : None
  • Emergency Action Code : 3[Z]
Regulatory Information
  • Supply : NO SYMBOLS REQUIRED
  • Carriage : LOW HAZARD
  • Risk and Safety Phrases :
  • S37 – Wear suitable gloves.
  • S42 – During spraying wear suitable
    respiratory equipment.
  • S43 – In case of fire use sand, earth,
    foam or water fog.
  • S51 – Use only in well ventilated areas.
  • S62 – If swallowed, do not induce vomiting : seek medical advice inmediately and show this container or label

Reference should be made to Health and Safety at Work Act and Control of Substances Hazardous to Health Regs.

Other Information

A mixture of light lubricating oil and fatty acids.

The information given in this document has been compiled on the basis of best available knowledge in accordance with the requirements of the Chemical Hazard Information and Packaging Regulations 1994(Am 1996). It does not imply that the information is complete or accurate in all cases. It is the user’s responsibility to satisfy him/herself as to the application of the information and/or the recomnendations given for his/her own use.

Revision Number 2 Dated 96/07/11

ORDER CODE
Description
14 CRA 20
‘CRA3’ Safer Release Agent – 56 gallon drum
Contact us
1